China 15.6 inch touch screen for laptop display Manufacturer, Supplier, Factory

The VXT350QHI-26C is a 3.5-inch 320 x 480 portrait TFT LCD module with a capacitive touch panel, driven by ILI9488, and what sets it apart is that three interface families sit on one 50-pin FPC - 24-bit RGB, MCU parallel in 8, 9, 16, 18 or 24-bit form, and SPI - selected by three IM strap pins. The touch is a mutual-capacitance sensor on its own separate 20-pin FPC carrying seven TX and five RX lines. An active area of 48.96 x 73.44 mm whose 2:3 aspect matches the dot matrix precisely, and a diagonal of 88.265 mm, or 3.4750 inches. Contrast is 700 typical, all four viewing angles are 80 degrees with an ALL viewing direction so the module mounts any way round, uniformity carries a floor of 75 per cent, NTSC is 69 typical, and all eight CIE coordinates are published. The backlight is six LEDs in parallel at 120 mA with a forward voltage from 2.7 to 3.3 V, so a 3.3 V rail leaves no headroom and the current is high for a parallel array.

The VXT800BYH-01 is an 8.0-inch 800 x 1280 portrait TFT LCD module driven by an HX8260 over a 4-lane MIPI DSI interface on a 24-pin FPC, and the reason a panel this size ships on 24 pins is the interface. Four differential data lanes plus one differential clock pair carry what a 24-bit parallel RGB bus would need fifty pins to carry, so a 1,024,000-pixel display fits a host with a DSI peripheral and almost no other pins to spare. It is the most portrait panel here - 800 x 1280 in a 16:10 column - with square 0.13455 mm pixels at 188.8 PPI, 16.7M colours stated outright, and a diagonal of 203.09 mm that lands within 0.05 per cent of the nominal 8.0 inch. And TE is brought out on pin 4, which is the tearing effect output: with a 2.0 MB frame buffer too big to double cheaply, being able to stay single-buffered and still write tear-free is the difference between a workable design and an expensive one. Three things need settling before you commit. The logic voltage is stated two ways and they do not agree: pin 7 is annotated IOVCC 1.8V while the electrical table's supply-voltage-for-logic row gives 2.8 V typical, and the thresholds are written as fractions of VDD without saying which rail, so a 1.8 V host is either comfortably inside or well outside depending on which figure holds. The storage temperature runs -30 to +70 against an operating range of -20 to +70, so the high end is not wider at all - storage should be wider at both ends and here it is not. And the backlight's seven-in-series array is derived rather than stated, and it puts 27 mA through each string against a 30 mA absolute maximum.

The VXT350LQZ-01P is a 3.5-inch 320 x 240 QVGA TFT LCD module with a 4-wire resistive touch panel, and the touch specification is the reason to look at it. Section 6 publishes what almost nothing in this size does: linearity of +/-1.5% after environmental and life testing, terminal resistance per axis, insulation resistance of 20 megohms minimum, response time under 10 ms, light transparency of 78% minimum, operation force of 80 gf typical, surface hardness of 3H minimum, 100,000 pen sliding cycles and 1,000,000 hitting cycles - with the test conditions for each. Two other figures are unusually trustworthy. Brightness carries both a floor and a ceiling, 280 minimum and 420 maximum around the 350 typical, so you can see the production spread as well as the worst case.The viewing angles are the narrowest in our range at 25 degrees typical on one horizontal side and 45 everywhere else, and while the specification states a 6 o'clock viewing direction, it is the horizontal pair that is asymmetric rather than the vertical one - so confirm the orientation with us and expect a narrow cone.

Victronix is a professional TFT module manufacturer and supplier in China. We have been in this field for 18 years and have developed several models. In addition to our standard products, we also offer a customized service to meet our customers' needs. This Victronix 4.3 inch automotive outdoor TFT module is a sturdy 4.3 inch TFT-LCD module designed for challenging automotive and outdoor applications. Combining high-brightness display technology with extended temperature resilience, this module delivers exceptional visual performance in harsh environments. Featuring a 480×RGB×272 resolution with 16.7 million colors within a compact 95.04×53.86 mm active area, it provides crisp visuals with wide viewing angles up to 80° (CR>10) in all directions.

The VXT430MPSA-16 is a 4.3-inch TFT LCD module with 480x272 resolution and a true 24-bit RGB888 interface, built around a backlight rated for 50,000 hours — the longest in our range and roughly two and a half times the 20,000-hour life of our high-brightness 4.3-inch module. Sixteen LEDs share the load across eight series pairs, which is why it lasts. It ships without touch, so you fit your own or none at all. Rated -30 to +80°C for panel and control equipment that runs continuously.