China 1024x600 industrial TFT display Manufacturer, Supplier, Factory

This Victronix 9 inch 800x480 TFT Module is a high-performance 9 inch TFT LCD module engineered for demanding industrial applications. Featuring an 800×480 RGB resolution and a 16:9 aspect ratio, it delivers crisp, vibrant visuals with an active display area of 198.0 × 111.7 mm (7.80 × 4.40 inches). The module leverages a 24-bit RGB interface and advanced driver ICs (HX8664-B + HX8264-E) for seamless integration and reliable signal processing.

The VXT430PNO-01 is a 4.3-inch TFT LCD module at 480 x 272, The specification states the recommended viewing direction as ALL and names the technology as MVA, gives 80 degrees in all four directions, and leaves the grey-scale inversion direction blank - three consistent signals that mean there is no wrong way to mount it. On a TN panel a preferred direction and an inversion direction are stated, and a unit mounted where the operator looks up at it can land on the wrong side; here that decision disappears. The frame buffer is 255 KB, small enough that a microcontroller with 512 KB of internal SRAM needs no external RAM at all. Luminance is 280 minimum against 350 typical and 420 maximum, so there is a floor to hold us to and a ceiling that shows the spread. The backlight is twelve LEDs in six series strings of two, at 19.2 V and 40 mA drawing 0.768 W, with 30,000 hours minimum life. Reliability runs nine tests at 240 hours including vibration, ESD and an MTBF of 50,000 hours. Two cautions.

The VXT121QXHA-01 is a 12.1-inch TFT module with 1024 x 768 pixels, and it is the only 4:3 panel in our 12.1-inch range — the other two are 1280 x 800. That matters because XGA in a 4:3 layout is what a very large installed base of industrial controllers, medical instruments and test equipment was designed around, and it remains the usual target when a display in existing hardware has to be replaced. The active area is 245.76 x 184.32 mm with pixels that are square to ten decimal places, so circles and dial scales stay true. Brightness is 1000 cd/m², the highest figure we publish in this size, and the viewing angle is 85° in all four directions with no stated best direction. The interface is 4-lane LVDS on a 20-pin connector, and it runs from a single 3.3 V rail — no separate gate or analogue supplies to generate. We are equally direct about what this module demands and what is not yet documented: the backlight draws about 14 W, which is over 90% of the module's total power and needs a real thermal plan; brightness and viewing angle are given as typical values without stated minimums; and the driver IC, outline dimensions and LVDS data mapping are not in the file we hold.

The VXO-011AMA-097 is a 1.1-inch AMOLED in a 7:3 portrait format — taller, relative to its width, than any other display we make. A band's width is fixed by the strap but its height is not, and against our 0.95-inch band module this panel gives 294 rows instead of 240: 22.5% more vertical content for 1.5% more width. Same driver, same interface, same touch — just more room to stack readings. It also has touch on its own independent supply rails, so the touch layer can stay awake while the display sleeps. No backlight, 60,000:1 contrast, 420 cd/m², about 0.058 W at full white. RM69310, SPI, -20 to +70°C.

The VXT430HPWA-03C is a 4.3-inch TFT LCD module with 480x272 resolution and integrated capacitive touch, wired as two independent subsystems: the display runs on its own 40-pin interface and VDD rail, while the FT5446 touch controller has a separate 6-pin FPC and its own VDD-CTP supply. That lets you power the display down and keep touch alive, or reset touch without touching the display. Rated 850 cd/m² and -30 to +85°C, it suits outdoor handheld terminals, field instruments and portable equipment.

Victronix VXT700WHA-04: a high brightness wide temperature 7.0-inch 800 x 480 TFT LCD module, and two numbers define it. It delivers 1000 cd/m2 typical surface luminance from a 27-LED backlight at 27 V and 180 mA for the stated 4.86 W, putting it in daylight-readable territory, and it carries an operating range of -30 to +85 C with storage at -40 to +90 C. Driven by HX5281 over LVDS on a 40-pin 0.5 mm Hirose FH52-40S-0.5SH connector, it is transmissive and normally black with an ALL viewing direction, 16.7M colours, contrast 800 minimum and 1400 typical, response 25 ms typical and 35 ms maximum, uniformity 80 per cent minimum. ESD is the strongest in the range at 8 kV contact and 15 kV air. Brightness is stated at 1000-1100cd/m2.