China wide aspect TFT display Manufacturer, Supplier, Factory

This Victronix 9 inch 800x480 TFT Module is a high-performance 9 inch TFT LCD module engineered for demanding industrial applications. Featuring an 800×480 RGB resolution and a 16:9 aspect ratio, it delivers crisp, vibrant visuals with an active display area of 198.0 × 111.7 mm (7.80 × 4.40 inches). The module leverages a 24-bit RGB interface and advanced driver ICs (HX8664-B + HX8264-E) for seamless integration and reliable signal processing.

The VXT350PNO-01P is a 3.5-inch 480 x 272 TFT LCD module with a 4-wire resistive touch panel, Resistive sensing responds to pressure rather than to a finger's conductivity, so it works with gloves, wet hands, a stylus or a tool tip - which is why it remains the choice for industrial and medical equipment. The backlight is the most trustworthy figure in the document, because it is confirmed three independent ways: the block diagram states the circuit as 1 * 6LED, six in series; 19.2 V over six gives exactly 3.20 V per LED, which is the typical forward voltage the electrical table states; and the connector carries one cathode and one anode, which is what a single string looks like. Reliability is equally solid - nine tests, all at 240 hours, with a stated 50,000-hour MTBF.

The VXO-119AMA-044 is the first AMOLED module in our range, and that changes more than a specification line. Every other display we make is a TFT LCD with a backlight — an LED string, a driver, often a boost converter, and a brightness that fades. This panel has no backlight at all: each pixel makes its own light, so black is truly off. That gives 60,000:1 contrast, removes the largest power load in the module, and makes it thinner. It is a 1.19-inch round panel at 390x390 and 326 PPI, the sharpest we make, with four interface options — MIPI 2-lane, 3-wire SPI, 4-wire SPI and QAD-SPI — so you can bring it up on SPI and ship on MIPI. About 0.098 W at full white, 1 µA deep standby. RM69330, -20 to +70°C.

The CTP-T700IXN-06C is a 7-inch capacitive touch panel in G+G construction, and the most completely specified one we publish — outline, view area, drive IC, interface, I2C address, touch-point count and connector are all stated, so you can design with it straight away. It uses an FT5426 controller over I2C, supports five touch points, and is rated ≥7H. The gasket carries double-side tape, so it fits to a display without bonding equipment. Built for industrial HMI, control panels, portable terminals and retrofit work.

The CTP-VX116B5741-GG is an 11.6-inch capacitive touch panel in G+G construction, sized for 1366x768 displays. Transmittance is at least 85% with ≥6H hardness, response is ≤12 ms. Suited to portable terminals, industrial tablets, POS, medical devices and vehicle displays.

The VXT101BAHA-01C pairs a color TFT LCD with GT928 capacitive touch control. Its dedicated I2C touch connection and LVDS display interface suit embedded designs that bring on-screen controls, equipment readings and status information into one operator panel.