China 3.3V TFT LCD module 7 inch Manufacturer, Supplier, Factory

3.5" 320x480 portrait TFT LCD, 2.2 mm thin, 360 cd/m2 with floor and ceiling. SPI + 18-bit RGB, TE out, 1.65 V logic. This 3.5 inch TFT display by Victronix is commonly used in industrial HMI, medical diagnostics, portable instrumentation, and embedded control systems.

The VXT350MLH-03P is a 3.5-inch 320 x 240 TFT LCD module with a 4-wire resistive touch panel, and resistive sensing works with gloves, wet hands or a stylus. The brightness 200 cd/m2 minimum with the touch panel fitted, contrast 300 minimum and NTSC 50% minimum - and because brightness is also published without the touch panel at 300 cd/m2

The VXT104QXHA-02-B is a 10.4-inch TFT LCD module with 1024 x 768 XGA resolution and an HDMI input — the first HDMI module in our range, and the difference is the point. Every other module we sell is a component you have to drive: your processor needs the right peripheral, your firmware needs an initialisation sequence, your board needs a frame buffer, and your power design needs the sequencing right. This one includes the driver PCBA, so it takes HDMI from a single-board computer, an industrial PC, a media player or a laptop and shows a picture. There is no display interface to design and no 1.5 MB of frame memory to find in your host. It is also the easy answer when an old XGA panel fails: you do not have to reproduce the original interface, just feed it HDMI from the new computer. Power comes from a 12 V DC jack or 5 V over the HDMI connector, with the jack recommended because no input current is published. Brightness is 600 cd/m² with contrast at 600 minimum and 800 typical, viewing angle 80° in all four directions, and pixels square to within 0.002% so circles need no correction. We are equally plain about what the document does not settle: no LED forward voltage or backlight power, no input current, brightness and viewing angle carry typical values with no minimums, the supported HDMI video modes are not listed, and the outline drawing is missing from the file.

The Victronix VXT700QAEW-01C arrives as a finished touch assembly rather than a bare panel. A projected-capacitive sensor, a 0.70 mm cover lens and the display cell are built into one bonded stack — G+G construction, 6H surface hardness, at least 85% light transmittance — so there is no second touch part to source, no alignment step, and no bonding process in your build. Luminance is 850 cd/m² typical with an 80/80/80/80 viewing angle, video comes in over 40-pin LVDS driven by EK79001HN and EK73215BCGA, and touch is managed by an ILI2130 controller. Rated -30°C to +85°C.

The VXT700YIA-02C combines a portrait TFT display with an optically bonded capacitive touch panel. Its tall viewing area suits scrolling menus and guided workflows, while 10-point touch supports interactive functions through compatible host software.

The VXT101BAH-02 is a 10.1 inch color TFT LCD module for equipment that uses separate buttons, keypads or host controls. Its landscape display and LVDS interface provide a platform for presenting menus, measurements and operating information.